Digitizer
  Select the digitizer you wish to monitor. This will be unique to the Temperature Monitoring screen and not change the selected digitizer elsewhere in the software.

Probe Hardware
  If the selected digitizer is marked in the Configuration screen to require checking on selection (normally because the digitizer hardware is incomplete or under test) you will be prompted to use this function. Can be used at any time to check the digitizer hardware.

Period
  Sets the display update period when in Auto Update mode

Start AutoUpdate/Stop AutoUpdate
  Causes the screen to enter/exit the Auto Reload mode of operation

Log Temperatures
  The available temperature monitors are updated and set to the Elog

Note: The Reload button causes the temperature monitors to be read and the display updated.


The temperature monitors are displayed in green if within normal range (FPGAs 20C => 40C; PSUs 20C => 35C). If low the temperature is displayed in blue and if high it is displayed in red.