Digitizer
  Select the digitizer you wish to operate on. This will be unique to the Diagnostics screen and not change the selected digitizer elsewhere in the software.

Probe Hardware
  If the selected digitizer is marked in the Configuration screen to require checking on selection (normally because the digitizer hardware is incomplete or under test) you will be prompted to use this function. Can be used at any time to check the digitizer hardware.

FPGA
  Select the Digitizer module to be accessed

Address Modifier
  Select the address width to be used for hardware accesses. Normally 16 bit (A16) is used but 32 bit (A32) is also supported.

Address/Command
  Enter the hardware address within the selected FPGA to be accessed.

Set Data
  The data to be used for single cycle write accesses (ie using the "Do Set" operation)

Read Block Length
  The number of accesses to be made when using the "Do Read Block" operation

Write Block Data
  The data to be used for block write acccesses when using the "Do Write Block" operation. The number of data items (space separated) will be used to determine the Write Block Length.


Note: Documentation on the ADC software interfaces is available.  These replace the current screen. Use the browser Back function to return to this screen.