
\chapter{Inventory of module parts}

\section{Baseplate}

\begin{itemize}
\item Baseplate
\begin{itemize}
\item 10 x sixteen pin glass feedthroughs, plus O-rings
\item 40 x M2.5 8mm allen head screws, plus washers
\item Blanking plug for beam-pipe exit
\item Beam-pipe cavity O-ring
\item Four small counter sunk screws (vacuum relieved)
\item A `gas in' and `gas out' SwageloK fitting
\item 12 x vacuum feedthrough conhex connectors
\item 4 x baseplate support legs
\item 4 x M4 24mm allen head screws
\item Baseplate O-ring
\item 3 x baseplate PCB's
\item 3 x bundle of three coloured wires. Pink is 130mm, purple is 230mm and yellow is 150mm
\item 1 x gas bias lead
\item 8 x 187mm threaded rods
\item 4 x 174mm threaded rods
\item 8 x nuts and washers
\item 2 x handles
\end{itemize}
\end{itemize}

\section{CsI scintillators}
\begin{itemize}
\item CsI detectors (per detector)
\begin{itemize}
\item 2 x brackets
\item 2 x springs
\item 2 x allan cap screws 47mm
\item 2 x nuts/washers
\end{itemize}
\end{itemize}
\begin{itemize}
\item Legs x 4 [A2-32/8052]
\begin{itemize}
\item 8 x M2.5 allan screws 8mm, vac. relieved
\item 8 x M2 screws 6mm, vac. relieved
\end{itemize}
\end{itemize}
\begin{itemize}
\item CsI scintillator mount [A0-32/8045]
\item Clamp [A0-32/8046]
\item 4 x screws for corners
\item 4 x 60mm threaded rods
\item 4 x nuts
\item 9 port CsI ribbon cable (8 for central module)
\end{itemize}

\section{PSD and Gas Detectors}

\begin{itemize}
\item Spacers
\begin{itemize}
\item 4 x 4mm spacers
\item 4 x 6mm spacers
\item 4 x 24mm spacers
\end{itemize}
\end{itemize}
\begin{itemize}
\item PSD printed circuit board
\item Gas section
\begin{itemize}
\item Cathode grid
\item Anode grid
\end{itemize}
\end{itemize}

\section{Vessel}

\begin{itemize}
\item Mylar window glued to frame
\item Beam pipe (for central module)
\item Vessel O-ring
\item 16 x M4 16mm screws
\item 16 x M4 23mm screws
\item Vessel blanking plate - aluminium
\item Window clamp
\end{itemize}

\section{Detectors}

\begin{itemize}
\item 8/9 PSD's
\item 8/9 CsI scintillators with pre-amplifiers
\end{itemize}

\section{Miscellaneous}

\begin{itemize}
\item 3 x Pre-amp packs
\item Multi-meter
\item Oscilloscope
\item CHARISSA amplifiers
\item CsI scintillator signal cable
\item Calibration grid
\end{itemize}
